RADIO CONTROL
-
All model flying shall be conducted in a manner to avoid over flight of unprotected people.
-
I will have completed a successful radio equipment ground-range check before the first flight of a new or repaired model aircraft.
-
I will not fly my model aircraft in the presence of spectators until I become a proficient flier, unless I am assisted by an experienced pilot.
-
At all flying sites a safety line or lines must be established, in front of which all flying takes place. Only personnel associated with flying the model aircraft are allowed at or in front of the safety line. In the case of airshows or demonstrations a straight safety line must be established. An area away from the safety line must be maintained for spectators. Intentional flying behind the safety line is prohibited.
-
I will operate my model aircraft using only radio-control frequencies currently allowed by the Federal Communications Commission (FCC). Only individuals properly licensed by the FCC are authorized to operate equipment on Amateur Band frequencies.
-
I will not knowingly operate my model aircraft within three (3) miles of any preexisting flying site without a frequency-management agreement. A frequency-management agreement may be an allocation of frequencies for each site, a day-use agreement between sites, or testing which determines that no interference exists. A frequency-management agreement may exist between two or more AMA chartered clubs, AMA clubs and individual AMA members, or individual AMA members. Frequency-management agreements, including an interference test report if the agreement indicates no interference exists, will be signed by all parties and copies provided to AMA Headquarters.
-
With the exception of events flown under official AMA Competition Regulations rules, excluding takeoff and landing, no powered model may be flown outdoors closer than 25 feet to any individual, except for the pilot and the pilot's helper(s) located at the flightline.
-
Under no circumstances may a pilot or other person touch a model aircraft in flight while it is still under power, except to divert it from striking an individual.
-
Radio-controlled night flying is limited to low-performance model aircraft (less than 100 mph). The model aircraft must be equipped with a lighting system which clearly defines the aircraft's attitude and direction at all times.
-
The operator of a radio-controlled model aircraft shall control it during the entire flight, maintaining visual contact without enhancement other than by corrective lenses that are prescribed for the pilot. No model aircraft shall be equipped with devices which allow it to be flown to a selected location which is beyond the visual range of the pilot.
FREE FLIGHT
-
I will not launch my model aircraft unless I am at least 100 feet downwind of spectators and automobile parking.
-
I will not fly my model aircraft unless the launch area is clear of all individuals except my mechanic, officials, and other fliers.
-
I will use an effective device to extinguish any fuse on the model aircraft after the fuse has completed its function.
CONTROL LINE
-
I will subject my complete control system (including the safety thong where applicable) to an inspection and pull test prior to flying. The pull test will be in accordance with the current Competition Regulations for the applicable model aircraft category. Model aircraft not fitting a specific category shall use those pull-test requirements as indicated for Control Line Precision Aerobatics.
-
I will ensure that my flying area is clear of all utility wires or poles and I will not fly a model aircraft closer than 50 feet to any above-ground electric utility lines.
-
I will ensure that my flying area is clear of all nonessential participants and spectators before permitting my engine to be started.
SPECIALIZED SUPPLEMENTAL SAFETY CODES, STANDARDS AND REGULATIONS RADIO CONTROL COMBAT (#525)
GENERAL RADIO CONTROL RACING (#530)
GIANT SCALE RADIO CONTROL RACING (#515-A)
GAS TURBINE OPERATION (Note: Special waiver required) (#510-A)
These special codes and appropriate documents may be obtained either from the AMA Web site or by contacting AMA Headquarters.